Each section of this configuration file defines a service. I hope this helps someone who was stuck in the same situation as me. To create a new share location, add a section to the /etc/samba/smb.conf configuration file with these two definitions: sambashare path /sambashare read only No. This is what I've had to do, to thoroughly remove samba, when I couldn't get the system to boot. Unfortunately, you may also have to manually delete some items, because dpkg does not always delete startup scripts and other items the binary creates. Once it's booted all the way up, go through and do the sudo apt-get remove -purge samba samba-common command to make sure everything has been removed. Just use the commands as you would if you were in as root.īut I have had Samba cause a system to stop booting, and this is how I was able to rip samba out, and then do a clean install after I got the system booting all the way up again. Remember if you are in the recorvery mode shell, do not use sudo, because that will cause a seg fault. On Linux systems, you’re going to be using Samba to share and access files over SMB/CIFS. To get around that, you can use dpkg -purge -force-all samba and also for common and winbind if the system still wont boot. If you have a multi-operating systems environment, you can use Microsoft SMB/CIFS protocol to allow file sharing between Windows, Linux, and macOS systems. apt-get does not always work, in fact it will get you a seg fault in a recovery shell, atleast on Ubuntu from what I've seen. If you are stuck in recovery mode, IE the rescue disk. But what do you do if your system is not booting because of samba? These solutions all relay on the system booting.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |